Thermal modification of wood and a complex study of its properties by magnetic resonance

Posted by on May 25, 2016 3:12 pm
Categories: Top News

Heat treatment has proved to be an effective method of improving some of the useful properties of wood. Recent developments of the technology have allowed to achieve, among other things, increased hydrophobic properties, better elasticity, and improved dimensional stability.

The corresponding chemical modifications depend on the heating regimes and the heating atmosphere and involve degradation of hemicellulose, changes of lignin and cellulose structures and chemical wood composition due to wood extractives loss. Researchers from Institute of Physics of Kazan Federal University, Institute of Perspective Research Tatarstan Academy of Sciences, and Nanoscience Department of Institut Neel conducted an investigation of various thermally treated wood species from the Central European part of Russia by magnetic resonance methods and revealed important changes in wood structure which were not available for observation by other methods.

Magnetic resonance methods are very well known as non-invasive techniques that allow to obtain information on structure and processes inside samples.

The selection of sapwood samples included Scots pine (Pinus sylvestris), birch (Betula pendula), Russian larch (Larix sibirica), Norway spruce (Picea abies) and small-leaved lime (Tilia cordata) were vacuum treated by heat at 220 C with various durations up to 8 h.

Electron paramagnetic resonance experiments revealed changes in the amount of free radicals in samples with the thermal treatment duration. They proved that free radicals EPR signal amplitude strongly depends on the moisture content of the wood samples and decreases as the latter value grows. Additional EPR experiments with absorbed ethanol indicate a possible connection of this effect with the electric dipole properties of H2O molecules.

Observed changes in pore size distributions by microscopy methods indicate cell wall shrinking and deformation. This process is indirectly related to the mass loss and formation of stable free radicals detected by EPR method.Since the correlation between the EPR signal amplitude and wood hardness was found for larch, lime and spruce, it is possible to use EPR technique to assess the wood hardness.

Story Source:

The above post is reprinted from materials provided by Kazan Federal University. Note: Materials may be edited for content and length.

Leave a Reply

Your email address will not be published. Required fields are marked *